Limit PCB cutting and pasting capability

Limit PCB cutting and pasting capability
This article explains the limiting factors that limit PCB cutting and pasting capabilities
Given restrictions PCB cutting and pasting capabilities
The latest form of intelligent property (IP) entering the market is simple PCB design In order to be able to transfer known good designs to new projects, design automation vendors have installed software that allows engineers to cut and paste PCB layouts
This article explains the limiting factors that limit PCB cutting and pasting capabilities
Concerned about the rapid growth of high integrated silicon design costs, the shortage of layout engineers prompted major suppliers in the PCB field to transform their high-end tools to make up for some deficiencies.
Mark Ashton, Zuken's marketing director, said: "There is a lack of talents. In the United States, they now pay more for layout designers than EEs."
This article explains the limiting factors that limit PCB cutting and pasting capabilities
Design automation suppliers believe that the shortage of employees is driving customers to seek higher levels of automation. Recall that the concept of constraint management (setting rules on each PCB track to ensure correct wiring) in the mid-1990s is back.
This article explains the limiting factors that limit PCB cutting and pasting capabilities
Cadence Design Systems provides new support for constraint management, from schematic capture to layout, to the 14.0 version of Allegro software. Zuken Group plans to extend the constraint management system to HotStage 4 later this year.
Circuit board

This article explains the limiting factors that limit PCB cutting and pasting capabilities
The problem they want to solve comes from the large number of key traces still on the PCB. Ashton said, "The development of [system on chip] is not as fast as people expected. People are using multiple off the shelf chips because the cost of developing SoC is very low.
"You must be confident in the market forecast to choose SoC design instead of collecting cheaper off the shelf parts.
This article explains the limiting factors that limit PCB cutting and pasting capabilities
"But there is still a trend of shrinking and accelerating. In some cases, the circuit board is smaller than all the components expected, so they enter the PCB itself."
This article explains the limiting factors that limit PCB cutting and pasting capabilities
Gary Hinde, European Marketing Manager of Cadence PCB Group, said: "PCB layout can be IP, which becomes a factor to distinguish suppliers“
This article explains the limiting factors that limit PCB cutting and pasting capabilities
By combining constraints with known good layouts, Hinde indicates that the design can be transferred to new products, and still hopes to route them with the help of signal integrity analysis, so as to effectively achieve this goal through automation tools.
This article explains the limiting factors that limit PCB cutting and pasting capabilities
Drive the extension of signal integrity analysis to low-end products. For the newly released Cadstar, Zuken has promoted some of the EMC technologies obtained through iCases to the routing engine. The EMC inspection software in Cadstar 4.5 first identifies critical networks, and then analyzes whether these networks will cause problems after routing.